Unable to Get VIN Number response from OBD

I need to fetch VIN number from car's controller using plxKiwi-2 wifi obd2 device. I am getting other information like car rpm,speed,throttle position,etc. in correct format. But when I request for VIN Number it gives me below response.

014 0: 49 02 01 FF FF FF 1: FF FF FF FF FF FF FF 2: FF FF FF FF FF FF FF

which is invalid.In Hyundai's EON car, I got proper response for VIN Number,but in almost all other cars, I got above mentioned response. So is there any specific 'AT' command to get the proper VIN response ?? Please help.


After lot of searching, I came to the conclusion that it is not necessary that all the cars will respond its VIN Number.

It depends on the manufacturer whether he wants to disclose the Chassis number or not. So I was in the proper direction and was able to read VIN Number from many of the cars but not from all.

Hence,

  • NO DATA
  • For New Cars (Protocol Number > 5 , ie CAN Protocol)

  • 014 0: 49 02 01 FF FF FF 1: FF FF FF FF FF FF FF 2: FF FF FF FF FF FF FF
  • 014 0: 49 02 01 xx xx xx 1: xx xx xx xx xx xx xx 2: xx xx xx xx xx xx xx
  • And for Old Cars (Protocol Number <= 5 , ie NON-CAN Protocol supported cars)

  • 49 02 xx xx xx xx xx 49 02 xx xx xx xx xx 49 02 xx xx xx xx xx 49 02 xx xx xx xx xx 49 02 xx xx xx xx xx
  • responses are some of the valid responses ... And if we get VIN response from ECU, please cross-check that VIN number's length is exactly 17- alphanumeric characters.


    Already read the question, and had no idea ready. But since you've asked me to check it out, I'm going to give it a shot. You send the command 09 02 right?

    You can check with command 09 00 which commands in the VIN-mode (09 xx) are supported. You will get this bit-encoded answer from the car, and with that answer you can check if 09 02 is supported. (If you need help with the bit-encoding, please ask help, but it's not very hard with some googling). Looking forward if this match with your 09 02 reports.

    Most likely it will not be supported, and that will be the problem.

    I believe there is no AT command available to get the VIN, you need to use mode 09.

    Edit 1: Now I'm thinking about it, and it could be protocol related, but I have to do way much google-work to find that out. Might be an option to find out which protocols work for your VIN-reading.


    There is no mistake. You send the command "09 02" and the ECU replies with a positive response "49 ...". Indeed, it is strange that instead of getting the real vin you receive "0xFF...", but this is normal for Hyundai cars. I have seen this before in Hyundai vehicles - response with all bytes "0xFF".

    链接地址: http://www.djcxy.com/p/95110.html

    上一篇: 是否有ELM327 / obdkey OBD

    下一篇: 无法从OBD获取VIN号码响应